T38

We will present next, the necessary steps in order to configure the T38 protocol.

Note: The presented configurations should serve merely as an example.

At IPBrick.GT > Fax Server you will activate the FAX service. As soon as that is done there will appear three links on the top right corner of the page Modify, Fax interfaces and Fax Users

Figure 5.6: T38 - Fax Server

Click on Fax Interfaces and there will be two types of interfaces FoIP-SIP and FoIP-T38. Select the latter and create a new interface for your T38 operator.

Figure 5.7: T38 - Fax Interfaces

At Routes Management (IPBrick.GT > Fax Server > Routes Management) create the FAX routes in the same fashion as for the SIP routes.

Figure 5.8: T38 - FAX Routes

Click on Insert at Outbound Routes and add a route using the previously created interface. You may configure it as default gateway or as prefix.

Figure 5.9: T38 - Outbound Routes

You should now insert an inbound route.

Figure 5.10: T38 - Inbound Routes

The final result should be something like in the following figure:

Figure 5.11: T38 - Final result

In this example, the FAX default gateway is the T38 operator and the DDI 22XXXXXXX as an entry in T38.