At this page (Figure 7.81) you may insert failover switches.
Figure 7.81:
Telephony - Failover Switches
|
|
Click on Insert and fill in with the necessary information (Figure 7.82):
- Name: The failover switch name;
- IP: Its IP address;
- MAC Address: Its MAC address
- Keep-alive interval: A keep-alive signal is sent at predefined intervals (by default 5 seconds). If there's reply no change is done to the routing. If there's no reply the connection is assumed to be down and future data will be routed via another path until the link is up again.
Figure 7.82:
Telephony - Failover Switches Insert
|
|
IPBRICK
