Body

List of the available Public Interfaces (normally ETH1) and the state of the service for each network card. Clicking the state allows to move between active and inactive. Clicking the network plate allows to accede the management formulary of that service (Figure 5.14).

Figure 5.14: Network - QoS management

In Generic Configurations (Figure 5.15) is possible to define which maximum band width is allowed for download and upload.

In section Structure there are three classes of defined priorities, each one of them already with predefined filters. It is possible to define new filters for each priority class, specifying the following fields:

• Types of filter: ACK type (confirmation of packets reception) or General;
• ToS^5.3:
  • Minimizes the delay;
  • Maximizes debit;
  • Maximizes reliability;
  • Minimizes the cost;
  • Minimizes the cost;
• Protocol: Type of protocol to apply in the filter;
• Source IP;
• Source Port;
• Destination IP;;
• Destination Port.

The Priority Class 1 has always maximum priority, and the traffic is defined in Priority Class 3, the less importnt.

Figure 5.15: Network - QOS - General Configurations

Footnotes

... ToS^5.3

Type of Service